APL 1A Low Dropout Fast Response Positive Adjustable Regulator and Fixed V, V and V. Features. Guaranteed Output Voltage Accuracy within. APLVC-TU 1A Low Dropout Fast Response Positive Regulator Fixed V and V 1A, Details, datasheet, quote on part number: APLVC-TU. APLUC-TU from Anpec Electronics Corp.. Find the PDF Datasheet, Specifications and Distributor Information.
| Author: | Tygokinos Douzahn |
| Country: | Lesotho |
| Language: | English (Spanish) |
| Genre: | Travel |
| Published (Last): | 25 June 2005 |
| Pages: | 384 |
| PDF File Size: | 18.16 Mb |
| ePub File Size: | 1.23 Mb |
| ISBN: | 152-4-33106-170-6 |
| Downloads: | 32404 |
| Price: | Free* [*Free Regsitration Required] |
| Uploader: | Kagabei |
This will improve transient response as well as pro. Load Regulation When the adjustable regulator is used. X C should be approximately equal to R1 at ripple frequency ANPEC reserves the right to make changes to improve reliability or manufacturability without notice, and advise customers to obtain the latest version of relevant information ddatasheet verify before placing orders.
Load regula- tion will be limited by the resistance of the wire con- necting the regulator to the load. The APL output capacitor selection is dependent upon the ESR equivalent series resistance of the output capacitor to maintain stability. The output available volt- age range of an adjustable version is from 1.
On-chip thermal limiting dxtasheet protection against any combination of overload that would create excessive junction temperatures. Simplified Application Circuits 1. The output available volt. The data sheet speci.
APL1117 Datasheet
The device is available in an datsheet version and fixed output voltages of 1. When the adjustable regulator is used. The device is available.
On-chip thermal limiting provides. Best load regulation is obtained when the top of the resistor divider R1 is tied di- rectly to the output pin of the device, not to the load.
This will improve transient response as well as datxsheet mote stability. By plac- ing a resistor between these two terminals, a con- stant Current is caused to flow through R1 and down through R2 to set the overall output voltage. Normally this current is chosen to be the specified minimum load current of 10mA.
APL datasheet, APL datasheets, manuals for APL electornic semiconductor part
The data sheet speci- fication for load regulation is measured at the output pin of the device. For fixed voltage devices R1 and R2 are included in the device. Tantalum, or aluminum electrolytic capacitors can be used for bypassing.
For fixed voltage devices the top of R1 is internally connected to the output, and the ground pin can be connected datqsheet low side of the load. If R1 were con- nected to the load, RP is multiplied by the divider ratio, the effective resistance between the regulator and the load would be: In order to obtain lower dropout voltage and faster transient response, which is critical for low voltage applications, the APL has been optimized.
Dropout voltage is guar. For fixed voltage devices the top of R1 is internally.
APL1117 Datasheet PDF
Best load regulation is obtained. Home – IC Supply – Link. ANPEC reserves the right to make changes to improve reliability or manufacturability without notice, and. Proper capacitor daatasheet is important to ensure proper operation. X C should be approximately. Dropout voltage dattasheet guar- anteed at a maximum of 1. A low-ESR solid tantalum capacitor works extremely well and provides good transient re- sponse and stability over temperature. The APL is a low dropout three-terminal adjustable.
Basic Adjustable Regulator ues will improve ripple rejection by bypassing the in- put to the regulator. Current limit is trimmed to ensure specified output current and controlled short-circuit current.