INTRODUCTION. This service manual describes the latest service information for the ICH DUAL BAND FM TRANSCEIVER at the time of publication. View and Download ICOM ICH instruction manual online. DUAL BAND FM TRANSCEIVER. ICH Transceiver pdf manual download. View and Download Icom ICH operating manual online. VHF/UHF Radio. ICH Radio pdf manual download.
|Published (Last):||14 April 2006|
|PDF File Size:||6.35 Mb|
|ePub File Size:||20.3 Mb|
|Price:||Free* [*Free Regsitration Required]|
Call Channel Operation I Call channel selection Call channel is pre-programmed memory channel that can be accessed by simply pushing call channel button.
ICOM ICH INSTRUCTION MANUAL Pdf Download.
I Memory Clearing Table of Contents Add to my manuals Add. Don’t have an account? I Fuse Replacement This function cuts a transmission OFF after 1—30 min.
I Programming A Dtmf Code I Scan types Scanning searches for signals automatically and makes it easier to locate new stations 2720b contact or listening purposes. Starts and stops priority watch.
Scan Operation I Scan types Scanning searches for signals automatically and makes it easier to locate new stations for contact or listening purposes. The watch resumes according to the selected manial resume condition. When a high SWR antenna or no I Accessing A Repeater To prevent accidental, continuous transmissions with this function, the transceiver has a time-out timer.
Typically, AM mode is used for the air band — I Programming Memory Channels D Adjusting the transmit signal output from the TNC When setting data transmission speed to bps, the data signal coming from the TNC is applied exclusively to the in- ternal limiter circuitry to automatically maintain band width.
The squelch attenuator allows you to set a minimum signal level needed to open the squelch. I Priority Watch Operation Don’t have an account?
I Call Channel Selection I Skip Channel Setting To activate all functions access or to change frequency via the microphone, you must designate one band as the main band.
220h Transferring Memory Contents We manua, the locations shown in the diagram below. I Front Panel- Controller Outputs both left and right bands audio when no external speaker is connected to [SP-2]. When narrow is set, the transmission deviation and reception passband width become half of the wide setting approx. I Memory Channel Selection Selects low output power Selects minus duplex operation. I Squelch Attenuator Page 7220h 96 Go.
Thus the steps 3 and 4 may not be necessary, depending on the setting. Independent offset frequencies can be set for each operating frequency. Got it, continue to print. D Location Select a location which can support the weight of the trans- ceiver and does not interfere with driving. I Initial Set Mode janual I Programming A Call Channel This setting can be set for each memory, call and VFO inde- pendently.
ICOM IC-2720H Instruction Manual
I Partial Reset Using this function you can transmit without pushing and holding the PTT switch. I Function Display This may distort the signal. D Frequency lock This function locks [DIAL] and switches electronically and can be used together with the microphone lock function.
Each of these channels can be individually programmed with operating frequency pgs. Set the subaudible tone repeater tone encoder function ON.
ICOM IC-2720H Manuals
D bps packet operation q Connect the transceiver icmo a TNC as illustrated below. Roof-mount antenna Drill a hole or use a magnetic mount. Using The Mounting Bracket D Location Select a location which can support the weight of the trans- ceiver and does not interfere with driving. Don’t show me this message again. I Scan Types